Pinion Replacement For Suzuki

Article

Pinion replacement for suzuki can be a challenging job unless you have the right tools.pinon replacement for suzuki First, you will need a flange holding tool and a cold chisel to remove the existing drive shaft nut and seal. Use a depth gauge micrometer to measure the current pinions depth in the housing and write down this number. Install new seal and nut. While installing the nut, you should rotate the pinion while tightening it to check a pre load on the bearing. Tighten a little and check again, repeat until your pinion is at the correct depth.

Once your pinion is set, you can mark the ring gear to show the pattern you are looking for.

Pinon replacement for suzuki

Deja un comentario